xTool Laser Engrave- and Cutting machines / xTool P2S / xTool P2 Material Clamps (4x)
xTool P2 Material Clamps (4x)
xTool P2 material clamps can work with materials with a maximum thickness of 12 mm.
How to use?
Relevant products
xTool P2 material clamps can work with materials with a maximum thickness of 12 mm.
How to use?
1. Place a board or sheet on the slats.
2. Stretch a clamp by holding the lower part with one hand and pulling the upper part up with the other hand, and then place the clamp around the material and a slat.
3. Fit the other three clamps in the same way.
Do you have a question about this product?
Ask us your question
Ask a question about this product
Your question has been sent! Thank you.
We will provide you with an answer as soon as possible.
